Keltec P17 +6 Magazine Extension Base Plate (22+1) *NEW VERSION* 3D Printed

Description

Keltec P17 22lr +6 Magazine Extension.
Brings your P17 factory magazine from 16 rounds to 22 for a total of 23 in the gun (22+1). Designed and made in the USA, 3D printed using black PLA+.  Utilizes your factory P17 magazine body, magazine spring, and magazine lock plate.  Includes magazine extension that slides onto the base of your magazine, rear retaining block that bolts into a slot in the extension to lock the extension to the magazine, M3 bolt for retaining block and long ball point hex wrench for installation and take-down.
This is not a complete magazine, only an extended base plate system.
Installation:
>Remove factory base plate.  >Then use provided hex wrench to hold the spring and lock plate inside the magazine while sliding the extension onto the magazine.  >Slide extension as far back  as it will go until stopped against the hex wrench, then slide the hex wrench out from the side and fully seat the extension onto the magazine.  >You will hear a 'pop' when the spring and lock plate seat into the extension and you will see the lock plate nub inside the round hole on the bottom of the extension.  >Then use the small, square retention block and M3 bolt to securely lock the extension to the magazine bottom.  >Tighten the M3 bolt using the hex wrench until lightly snug.
Be careful not to over tighten.
The top of the M3 bolt should be close to or flush with the square edge of the retention block.  >You're ready to load and shoot!
Note: Only one hex wrench will be included per order, not per extension.  However, if you lose your hex wrench just send me a message and I'll send you another for free.  If you have any issues with installation or use, please message me and we'll get it fixed.  While not typical, it's possible that each magazine extension may need a slight break in.
See Live Demo Video Here.